instal the new version for android Autorun Organizer 5.38

So as you decided to ignore my warning, here we go: If you post about vulnerabilities and stuff better cover your ass - who knows what the legal department of philips thinks about your cool stuff.

For every one else: don't blame philips if you brick your device -> think before actually trying. WARNING: don't look at the following information nor try to use any of it if you have no clue about linux or android as it is most likely that you are going to break your expensive gadget. So, it would go like this (from 'getprop'): So if yours ends up stuck on the Philips logo, be sure to have that cable ready and have it plugged in, replug the power and then issue the command when you want to get out of that mode.Īs far as KingRoot 5.0.1 goes, it either fails or results in a kernel panic (as reported by the system). It would try booting back into the system if a fastboot reboot is done. I had noticed that the TV would remain in fastboot even if you replug it. There was a notice about there being no max download size being reported by the device and gone ahead and flashed the image successfully. I did a test flash of the recovery image using the one found in '/system/boot'. When it takes me to this mode, there can be a graphical glitch at first.

When I ADB reboot to the bootloader, it takes me to fastboot mode (requires a USB A male to USB A male cable from the TV to the PC). I was able to access the device via ADB over the network ever since that one firmware that appeared to have enabled it. I should probably share my discoveries so far with the QM152E. I'll repost it here but with some additional information outside of that after.

I had posted some information about the TV I currently own some time ago but on a not-so active thread. 40PUT6400/12 (QM152E) ADB, Fastboot and potential root information

Instal the new version for android Autorun Organizer 5.38